Friday, June 20th 2014

Zalman ZM-DF12 Smart Fans Begin Selling

Zalman's most advanced fan, the ZM-DF12, started selling. Built in the 25 mm-thick 120 mm form-factor, the fan features a 'dual-impeller' design, which works to increase air-flow, at lower speeds. The dual-impeller is basically two sets of blades spinning along a common motor. The motor features a nano-polymer bearing that has lower thermal deformation over time than common fluid-dynamic bearing types. The fan features a 'reversed' frame assembly. The frame holds the hub from behind, rather than the front. The back part of the motor hub hence doesn't spin along with the impeller. It instead features the fan's in-built controller, that lets you control speed in three steps - 800 RPM, 1,200 RPM, and 1,600 RPM. The fan takes input from a 3-pin connector. At its maximum speed, it pushes 63.76 CFM of air, with 33 dBA noise output.
Add your own comment

8 Comments on Zalman ZM-DF12 Smart Fans Begin Selling

#1
RejZoR
I wonder why no one makes thicker fans with lower RPM. They could use larger blades and thus push more air at lower RPM = silence. Many cases could easily utilize them. I think i could even use them in my mini ATX case.
Posted on Reply
#2
mr2009
max speed only churn out 64cfm and 33dba? didnt other brand have better cfm at much lower dba? i wonder if those small blade the one giving out the most noise...
Posted on Reply
#3
Fourstaff
mr2009max speed only churn out 64cfm and 33dba? didnt other brand have better cfm at much lower dba? i wonder if those small blade the once fiving out the most noise...
Possibly higher static pressure, but then again, if they don't advertise it we can safely assume its not high.
Posted on Reply
#4
micropage7
just moving half of blades forward from standard fins design
Posted on Reply
#5
CookieMonsta
RejZoRI wonder why no one makes thicker fans with lower RPM. They could use larger blades and thus push more air at lower RPM = silence. Many cases could easily utilize them. I think i could even use them in my mini ATX case.
I sometimes wonder this as well. 38mm thickness or even 50mm thick fans would also allow the usage of higher torque motors which would allow better static pressures.
Posted on Reply
#6
AsRock
TPU addict
Meh, and yet the put more plastic bars in the way of air flow.
Posted on Reply
#7
Behemot
RejZoRI wonder why no one makes thicker fans with lower RPM. They could use larger blades and thus push more air at lower RPM = silence. Many cases could easily utilize them. I think i could even use them in my mini ATX case.
They do. Industry fans from quality manufacturers (Delta, AVC, Papst etc.) but they are usualy turbines so you need to drive the voltage down (or get PWM versions). Also be ready to pay fortune for them…
Posted on Reply
#8
GreiverBlade
AsRockMeh, and yet the put more plastic bars in the way of air flow.
ever looked at a Silverstone air penetrator line? the AP have a lot on the back and yet they have a steady directed stream flow over 1m (not propaganda from their website, i tested it :D )ok it's not the same design and function :roll:
Posted on Reply
Nov 22nd, 2024 04:19 EST change timezone

New Forum Posts

Popular Reviews

Controversial News Posts