Friday, July 4th 2014

Dirac Launches Tesla Cube Series 550W and 650W SFX Power Supplies

Japanese PC hardware maker Dirac launched its Tesla Cube line of high-wattage PSUs in the SFX form-factor. The series includes 550W and 650W models, which should splash your build with enough juice to run single high-end or two performance-segment graphics cards. The two feature single +12V rail designs, efficiency that meets 80 Plus Gold standards, and a fully modular cabling design. The two also come with adapters that let you install them on standard ATX cases. Cables for both models include 24-pin ATX, 4+4 pin EPS, two 6+2 pin PCIe, six SATA, and one Berg. The 650W Tesla Cube displaces Silverstone's SX600-G in being the most powerful SFX power supply. Silverstone's unit was showed off at Computex 2014, and is headed for launch later this month.
Add your own comment

10 Comments on Dirac Launches Tesla Cube Series 550W and 650W SFX Power Supplies

#1
Debat0r
Why can't they just make a 350W Bronze SFX PSU that's modular ;-;
Posted on Reply
#2
RCoon
Debat0rWhy can't they just make a 350W Bronze SFX PSU that's modular ;-;
Why would you need 350W to be modular? You're going to have the 24pin, the 4/8pin and the molex and sata power cables being used, so what's left to be modular and not used?
Posted on Reply
#3
Debat0r
RCoonWhy would you need 350W to be modular? You're going to have the 24pin, the 4/8pin and the molex and sata power cables being used, so what's left to be modular and not used?
Custom cables?
And I only ever use one HDD so ;)
Posted on Reply
#4
AsRock
TPU addict
The series includes 550W and 650W models, which should splash your build with enough juice to run single high-end or two performance-segment graphics cards.
Had me thinking hell no.. 1st of the word should makes me think they are not too sure about their product and the Splash thing makes me think briefly..
Posted on Reply
#5
bogami
Completely modular version for mini PC. Cable mouding possible. nice.
Posted on Reply
#6
micropage7
colorful pins, if you have lego case it will match;)
Posted on Reply
#7
GeoffreyK
Not quite SFX: (W)125mm-(D)120mm-(H)63.5mm (Source: www.dirac.co.jp/tesla-cube-sfx-series/)

Better wattage, but also larger. SX600-G still the most powerful within SFX specs; obviously, if you can afford the extra mm, then great, but depending on your build, thinking this is actually SFX could get you into trouble.
Posted on Reply
#8
Vario
splashes you with juice.... :twitch:
Posted on Reply
#9
nem
wooww awesome psu, hope soon a respective review ^^
Posted on Reply
#10
Hood
These are 25mm wider than the actual SFX specs (SFX = 100w x 125d x 63.5h). Even assuming that the screw holes line up in a standard SFX case, you'd have to make sure your case could handle the inch or so increase in width. Personally I don't think the form factor is adequate for so much power and heat, you have to have very loud fans to cool a high-end graphics card and CPU in such a small case, water cooled or not. Until the cooling technology is smaller and more efficient (and quieter), high-powered SFF builds will always be a compromise. I prefer relatively low-powered components for mini-ITX builds, where heat is not such an issue. I agree with Debat0r, a modular 350w SFX would be a lot more useful to the average builder.
Posted on Reply
Dec 26th, 2024 13:29 EST change timezone

New Forum Posts

Popular Reviews

Controversial News Posts