Tuesday, September 2nd 2014

NZXT Introduces its New Source 340 Case

Forged from strong, cold-­‐rolled steel, the S340 exudes an air of confidence that only the most durable of cases is capable of exhibiting. Axing the optical bays and relocating the HDDs to a lower position opens the case up like never before, making this one of the easiest cases to build in ever. A grommet-­‐less cable management solution, alongside over twenty zip-­‐tie locations and plenty of space behind the motherboard tray gives you unprecedented cable management options for a mid tower case.

When it comes to keeping cool, the Source 340 is no slouch. With Kraken X61 compatibility in the front intake, X31 compatibility in the rear exhaust, and a total of up to three 140 mm or for 120 mm fans you have plenty of chilling options. Thick front panel cutouts allow unrestricted airflow to reach our fully filtered intake. The Source 340 comes with the standard accouterments that you would expect from a premium case, such as USB 3.0, filtered intakes, a PSU shroud, and quality materials. Easily one of the most durable cases we've ever made, the Source 340 boasts 360 degrees of steel casing, extremely minimal plastic use, and extra thick side panels.
The extremely compact mid tower form factor sits significantly further shorter length-­‐wise to allow you to fit the case into harder to fit areas and carry the case around much easier without sacrificing performance. The S340 is everything a new builder, an experienced modder, or any PC enthusiast needs without the distraction of bright lights or flashy paneling.
Add your own comment

14 Comments on NZXT Introduces its New Source 340 Case

#1
Petey Plane
NZXT's best looking case yet. Congrats to them for continuing to phase-out the optical drive.
Posted on Reply
#2
wotevajjjj
I haven't found a single picture of it yet. Does this case exist yet ?
Posted on Reply
#3
newtekie1
Semi-Retired Folder
Where are the power and reset buttons located? I like the completely flat front, but if the power and reset button are relocated to the top of the case that sucks. I hate cases with the buttons on the top, I always end up hitting them by accident.
Posted on Reply
#4
nickbaldwin86
dat case!!!! so sexy,... first time I have liked a NZXT, normally no many strange angles they are off putting
Posted on Reply
#6
adulaamin
I like it. Might be by next case. We just need to wait for it to be released and reviewed. :)
Posted on Reply
#7
MilkyWay
Best designed case i've seen in a long time.
It's a simple design but it doesn't look dumb, i really like it infact.
Posted on Reply
#8
Frick
Fishfaced Nincompoop
Hope it comes with a version without a window.
Posted on Reply
#9
RCoon
newtekie1Where are the power and reset buttons located? I like the completely flat front, but if the power and reset button are relocated to the top of the case that sucks. I hate cases with the buttons on the top, I always end up hitting them by accident.
2 USB 3.0, power, reset and I assume their customary minimal fan controller are situation at the top at the front.
Posted on Reply
#10
micropage7
looks nice but if they close opening on pci slot, it would be better
Posted on Reply
#11
LAN_deRf_HA
Do you still have to pop off the panel to get to the filter?
Posted on Reply
#12
xD3aDPooLx
NZXT Rep
newtekie1Where are the power and reset buttons located? I like the completely flat front, but if the power and reset button are relocated to the top of the case that sucks. I hate cases with the buttons on the top, I always end up hitting them by accident.
They are located at the top of the case in the right lower corner, near the front of the case.
adulaaminI like it. Might be by next case. We just need to wait for it to be released and reviewed. :)
Reviewers should have the case really soon.
FrickHope it comes with a version without a window.
If we do get enough demand for it, then we will consider it.
RCoon2 USB 3.0, power, reset and I assume their customary minimal fan controller are situation at the top at the front.
No fan controller on this case at all.
LAN_deRf_HADo you still have to pop off the panel to get to the filter?
Yes to get to the front filter only.
Posted on Reply
#13
Disparia
Very nice looking.

Now, make an mITX version :)
Posted on Reply
#14
xD3aDPooLx
NZXT Rep
JizzlerVery nice looking.

Now, make an mITX version :)
LOL.
Posted on Reply
#15
Naito
xD3aDPooLxIf we do get enough demand for it, then we will consider it.
If this case came in a window-less variant, I'd pre-order it in a heart beat. Some acoustic foam, a couple layers of 3M vinyl wrap, and a little bit of creativity is all you need to make this excellent case even better. I don't need a window to do that.
Posted on Reply
Add your own comment
Nov 7th, 2024 07:24 EST change timezone

New Forum Posts

Popular Reviews

Controversial News Posts