HOLES & CUT’s>> Bottom 120mm Intake, 2- front 120mm in case shell & Bezel for Intake, Rear 92mm Exhaust, 80mm right side panel intake for cpu, Rear Top 140mm intake, Top middle 120mm exhaust, 80mm Left & Right top side panel exhaust, 3- 80mm left lower side panel intake, square hole in motherboard tray for cpu heatsink access, Slot for 6 sata cables, Slot for PSU 24 pin plug, Removed metal that was blocking 135mm bottom intake fan for PSU, Removed metal from the top of motherboard tray so wire’s would clear side panel, Removed metal in front case shell for power & reset switch clearance, Removed bottom section of 3.5” drive cage for front 120mm fan clearance, Removed some metal from right side 5.1/2” drive bays for wire management. MADE>> Top drive bay & power supply cover’s using gloss black plexiglass then drilled 7/8”inch hole’s & cut modders mesh for the back side,> Hard drive cage that hold’s 5 HDD using black transparent plexiglass, then cut 80mm holes for left & right side for exhaust, then cut flames for the end using a bandsaw, cage will hang from the top of the case with screws & rest on the top of the power supply with a bottom plexiglass plate with rubber feet,> Front fan box using gloss black plexiglass with modders mesh for grills,> Gloss black plexiglass plate for memory cooler,> fan wirebox for 3 side 80mm fans,> front power, reset & hdd led plate cover using black transparent plxiglass, FIBERGLASS WORK>> 2 front 120mm fan ducts,> Back 92mm fan hole,> Back top 140mm fan hole,>Power, reset & hdd led relocated. SLEEVING & W/M>> Front I/O panel,>power, reset &hdd led,> Used self crimping sata power connectors for a clean inline look,> All black zip ties,> Wire’s attached to back side of motherboard try using self adhesive zip tie clips. FANS & PAINT>> 6 – 120mm > 3- 92mm > 6- 80mm > 1- 140mm > 3- 40mm > 1- Front Vantec vortex,> Alphcool panel, Lite-on burner, I/O panel & Case were painted with Black Gunmetal Candy Pearl paint that was applied with a spray gun, Clear coated then polished.