Cross Load Tests

For the generation of the following charts, we set our loaders to auto mode through our custom-made software before trying over a thousand possible load combinations with the +12V, 5V, and 3.3V rails. The voltage regulation deviations in each of the charts below were calculated by taking the nominal values of the rails (12V, 5V, and 3.3V) as point zero. We should note here that we only run this test with PSUs that have a capacity equal to or lower than 1.3 kW since it takes a long time to run and because its completion time increases exponentially as the capacity of a unit increases.

+12V Voltage Regulation Chart

5V Voltage Regulation Chart

3.3V Voltage Regulation Chart

Efficiency Chart

+12V Ripple Chart

5V Ripple Chart

3.3V Ripple Chart

5VSB Ripple Chart