TechPowerUp GPU-Z v2.59.0 Released

[btarunr]

TechPowerUp today released the latest version of the popular GPU-Z graphics sub-system information, monitoring, and diagnostic utility. Version 2.59.0 adds support for new GPUs, but also fixes a few important issues with the application. To begin with, support is added for the NVIDIA RTX 2000 Ada and RTX 1000 Ada Laptop GPUs. An application launch error on Windows 7 and Windows 8 systems reading "unsigned driver cannot load" has been fixed.

The other issues resolved mainly concern the way PCI resizable BAR status is detected. On external GPUs, resizable BAR status was appearing as "enabled." This has been fixed. eGPUs lack resizable BAR support due to the limitations of USB interconnect. On notebooks with NVIDIA Optimus GPUs that support resizable BAR, the status was being reported as "disabled" when the discrete GPU is sleeping, which has been fixed. Lastly, instances where resizable BAR support is reporting as "Yes" instead of "enabled" or "disabled" has been fixed. Grab TechPowerUp GPU-Z from the link below.

DOWNLOAD: TechPowerUp GPU-Z 2.59.0

• Fixed "unsigned driver cannot load" error on Windows 7/8
• Fixed Resizable BAR status showing "Yes" instead of Enabled/Disabled
• Fixed Resizable BAR status showing disabled when NVIDIA Optimus GPU is sleeping
• Fixed Resizable BAR status showing enabled on eGPUs
• Added support for NVIDIA RTX 2000 Ada and RTX 1000 Ada Laptop

View at TechPowerUp Main Site

 

[cjy815]

I hope NVIDIA RTX 3050 6GB is supported soon!

 

[W1zzard]

I hope NVIDIA RTX 3050 6GB is supported soon!

This should be supported already

 

[RedBlackAka]

I experience crashes with this version, it closes itself whenever I refocus the window through the taskbar or run the installer in the settings. Windows 10/4080S/551.86

 

[W1zzard]

I experience crashes with this version, it closes itself whenever I refocus the window through the taskbar or run the installer in the settings. Windows 10/4080S/551.86

and 2.58 / 2.57 work fine?

Just tested the installer flow, works fine for me

 

[cjy815]

There is an issue where the Die Size of NVIDIA RTX 3050 6GB is missing from the GPU-Z program. I hope this is resolved quickly.

 

[and111]

I have a problem since some time, when i start GPU-Z, my 3080 TUF goes from idle 30W to 110W power draw?! and stays there even when i close GPU-Z again. Reading the values with HWmonitor.​

 

[W1zzard]

I have a problem since some time, when i start GPU-Z, my 3080 TUF goes from idle 30W to 110W power draw?! and stays there even when i close GPU-Z again. Reading the values with HWmonitor.​

Do you have the sensor refresh rate set to some very high value? Anything else that makes your setup special?

 

[and111]

Do you have the sensor refresh rate set to some very high value? Anything else that makes your setup special?

Nope, everything on stock, even a reinstall of GPU-Z didnt change it. Only other programs I'm running along that might affect the GPU are Afterburner with an undervolt and Argus Monitor to control it's fan speed (deshroud).