• Welcome to TechPowerUp Forums, Guest! Please check out our forum guidelines for info related to our community.

Aerocool Launches the Strike-X One & Strike-X One Advance PC cases

Joined
Dec 6, 2011
Messages
4,784 (0.98/day)
Location
Still on the East Side
Taiwan-based Aerocool Advanced Technologies has just announced the European release of two new Strike-X Series mid-tower PC cases, the Strike-X One and Strike-X One Advance. Both models feature a steel structure, are painted black both inside and out, and have support for ATX and micro ATX motherboards, four 5.25-inch drive bays (with tool-free mounting systems), six 3.5-inch internal bays, a PSU dust filter, and pre-drilled holes for watercooling tubes and cables.

The Strike-X One has an I/O panel with two USB 2.0 ports, and is equipped with one 120 mm rear fan, while the Strike-X One Advance comes with two USB 3.0 ports, a 120 mm rear fan, and a front 120 mm fan with red LEDs. The Strike-X One and Strike-X One Advance cost 34.99 Euro and 39.99 Euro, respectively.



View at TechPowerUp Main Site
 
I'm sure Xigmatek will have something to say about the front panel design...
 
I'm sure Xigmatek will have something to say about the front panel design...

I was gonna say Xclio might have a problem with it too but the last time Xclio made a case with an X in it, i was still in highschool
 
It does look like you get a LOT of kit for the money though. Although the paint on my last Aerocool Case (Aerocool M40), decided to shed its skin after 2 years and I had to repaint it. (although i was planning to repaint it anyway.)
 
Why, upon glancing at the 1st image, did I get the feel that something was not right, that this chassis should be orange and Xigmatek?
 
Why, upon glancing at the 1st image, did I get the feel that something was not right, that this chassis should be orange and Xigmatek?
I don't think even Xigmatek could make something look that tacky.
 
I was going to say "not bad" but then I saw the big X on the front.

Way to completely ruin a case.
 
I don't think even Xigmatek could make something look that tacky.
I don't think so either, but it was the 1st that came to my mind.
I was going to say "not bad" but then I saw the big X on the front.

Way to completely ruin a case.
You could just chop it off.
 
I don't think so either, but it was the 1st that came to my mind.

You could just chop it off.

For once I want a case that I don't have to chop up :laugh:
 
Back
Top