• Welcome to TechPowerUp Forums, Guest! Please check out our forum guidelines for info related to our community.

Dirac Launches Tesla Cube Series 550W and 650W SFX Power Supplies

btarunr

Editor & Senior Moderator
Staff member
Joined
Oct 9, 2007
Messages
47,670 (7.43/day)
Location
Dublin, Ireland
System Name RBMK-1000
Processor AMD Ryzen 7 5700G
Motherboard Gigabyte B550 AORUS Elite V2
Cooling DeepCool Gammax L240 V2
Memory 2x 16GB DDR4-3200
Video Card(s) Galax RTX 4070 Ti EX
Storage Samsung 990 1TB
Display(s) BenQ 1440p 60 Hz 27-inch
Case Corsair Carbide 100R
Audio Device(s) ASUS SupremeFX S1220A
Power Supply Cooler Master MWE Gold 650W
Mouse ASUS ROG Strix Impact
Keyboard Gamdias Hermes E2
Software Windows 11 Pro
Japanese PC hardware maker Dirac launched its Tesla Cube line of high-wattage PSUs in the SFX form-factor. The series includes 550W and 650W models, which should splash your build with enough juice to run single high-end or two performance-segment graphics cards. The two feature single +12V rail designs, efficiency that meets 80 Plus Gold standards, and a fully modular cabling design. The two also come with adapters that let you install them on standard ATX cases. Cables for both models include 24-pin ATX, 4+4 pin EPS, two 6+2 pin PCIe, six SATA, and one Berg. The 650W Tesla Cube displaces Silverstone's SX600-G in being the most powerful SFX power supply. Silverstone's unit was showed off at Computex 2014, and is headed for launch later this month.



View at TechPowerUp Main Site
 
Why can't they just make a 350W Bronze SFX PSU that's modular ;-;
 
Why can't they just make a 350W Bronze SFX PSU that's modular ;-;

Why would you need 350W to be modular? You're going to have the 24pin, the 4/8pin and the molex and sata power cables being used, so what's left to be modular and not used?
 
Why would you need 350W to be modular? You're going to have the 24pin, the 4/8pin and the molex and sata power cables being used, so what's left to be modular and not used?
Custom cables?
And I only ever use one HDD so ;)
 
The series includes 550W and 650W models, which should splash your build with enough juice to run single high-end or two performance-segment graphics cards.

Had me thinking hell no.. 1st of the word should makes me think they are not too sure about their product and the Splash thing makes me think briefly..
 
Completely modular version for mini PC. Cable mouding possible. nice.
 
colorful pins, if you have lego case it will match;)
 
Not quite SFX: (W)125mm-(D)120mm-(H)63.5mm (Source: http://www.dirac.co.jp/tesla-cube-sfx-series/)

Better wattage, but also larger. SX600-G still the most powerful within SFX specs; obviously, if you can afford the extra mm, then great, but depending on your build, thinking this is actually SFX could get you into trouble.
 
splashes you with juice.... :twitch:
 
wooww awesome psu, hope soon a respective review ^^
 
These are 25mm wider than the actual SFX specs (SFX = 100w x 125d x 63.5h). Even assuming that the screw holes line up in a standard SFX case, you'd have to make sure your case could handle the inch or so increase in width. Personally I don't think the form factor is adequate for so much power and heat, you have to have very loud fans to cool a high-end graphics card and CPU in such a small case, water cooled or not. Until the cooling technology is smaller and more efficient (and quieter), high-powered SFF builds will always be a compromise. I prefer relatively low-powered components for mini-ITX builds, where heat is not such an issue. I agree with Debat0r, a modular 350w SFX would be a lot more useful to the average builder.
 
Back
Top