Share your AIDA 64 cache and memory benchmark here

[freeagent]

Looking to reduce vdimm here and I'm not sure that Aida 64 really suffers that much going from 3800c14 down to 3800c16.

You could drop to C15 2T GDM off and its still not bad.. That puts me somewhere in the upper mid 1.4v range..

 

[tabascosauz]

Looking to reduce vdimm here and I'm not sure that Aida 64 really suffers that much going from 3800c14 down to 3800c16.

View attachment 215314

What are you at volts-wise right now?

Temps look pretty good so unless you're at 1.55V already there's not much reason to sacrifice timings to reduce vdimm.

I run 14-15-15 at basically exactly the same timings, 140ns, 1.52V. I haven't noticed a real world difference dropping from 3800 14-15-15 to 3600 14-14-14 but not sure about CL16. AIDA doesn't reveal much about real performance

 

[glnn_23]

What are you at volts-wise right now?

Temps look pretty good so unless you're at 1.55V already there's not much reason to sacrifice timings to reduce vdimm.

I run 14-15-15 at basically exactly the same timings, 140ns, 1.52V. I haven't noticed a real world difference dropping from 3800 14-15-15 to 3600 14-14-14 but not sure about CL16. AIDA doesn't reveal much about real performance

In this run I am 3800c16 @ 1.35 Vdimm.
This was to help a local fellow who was experiencing high temps running 3800c14 @ 1.525v. I suspect it it has more to do with temps inside his case.
Put it up here also in case someone else has temp issues.

 

[freeagent]

As long as you are moving a good amount of air through the case you should be able to run 1.55v just fine.

 

[tabascosauz]

In this run I am 3800c16 @ 1.35 Vdimm.
This was to help a local fellow who was experiencing high temps running 3800c14 @ 1.525v. I suspect it it has more to do with temps inside his case.
Put it up here also in case someone else has temp issues.

Is it a 4DIMM setup? 2 dual rank DIMMs should never have any problems with a small fan blowing on them. A top exhaust fan to clear hot air from the area also helps, but priority is direct airflow.

4DIMM is a little bit harder but @freeagent manages just fine with raw airflow.

If it's destabilizing bc of temps, then he's not got enough airflow.

For me, the difference between fan and no fan is basically 1.37V vs 1.52V. And the 1.52V still runs 5c cooler

 

[zebra_hun]

Hello everyone, i share my results here.
I9 10850k
Gigabyte Z490 Elite AC
G.Skill 2x16 Gb DRank kit
1. Pic: TB
2. Pic: Original XMP 3200 MHz
3. Pic: 4266 MHz, Dram 1,5V, IO & SA 1.31V
4. Pic: 4600 MHz, Dram 1.6V, IO 1.35V, SA 1.38V

 

[freeagent]

Just for fun..

 

[Fouquin]

Older system trying to keep up.

 

[jayjr1105]

Not sure how this stacks up for a 3733 kit with somewhat loose timings. This kit is actually advertised at CL17 but my XMP profiles keep it at 18 for some reason.

A bit more info on my RAM. Hynix CJR

 

[glnn_23]

 

[Fouquin]

Little VIA controller trying so hard. *Sad trombone*

 

[Fouquin]

Another sad trombone. The latency is actually quite good, but the throughput numbers are terrible. Numbers I have on hand for PC3200 CL2.5 on i865PE+NW 3.4Ghz are 4967/4199/4022/111.2ns.

 

[ThrashZone]

Hi,
Looks good only thing that's bad is the internet explorer icon lol

 

[AVATARAT]

Ryzen 5 5600x+PBO+CO Per Core
2x8GB DDR4@4066MHz 16-17-14-28-2T

Read: 60664 MB/s
Write: 32532 MB/s
Copy: 56055 MB/s
Latency: 50.9 ns

 

[Det0x]

Over theoretical max read, write and copy bandwidth numbers for 1900:3800 speeds
... With a dual CCD cpu running dual rank memory

Full screenshot:

With timings that are testmem 1usmus 25 cycles stable:


*edit*

Guess i can also show my living room TV-computer @ daily 24/7 settings (also Testmem 1usmus 25 cycles stable)

APU's are so easy to tweak its not even funny, think i spent like 2 mins in the bios in total to achieve this

 

[freeagent]

Just for fun..

 

[JCL]

Lowest memory latency and lowest L3 so far.

 

[freeagent]

I had to plug my 5900X back in.. only 1.45v on the mems.. Just running the Royals for now.. 2 sticks is easier to have some fun with anyways.. My board only runs up to 1.85 vdimm.. booo. Over 1.65v or so doesn't really get me much.. need that extra bump to 2v or so

 

[Cowboystrekk]

Over theoretical max read, write and copy bandwidth numbers for 1900:3800 speeds
... With a dual CCD cpu running dual rank memory

View attachment 217994

Full screenshot:
View attachment 217995

With timings that are testmem 1usmus 25 cycles stable:
View attachment 217999

*edit*

Guess i can also show my living room TV-computer @ daily 24/7 settings (also Testmem 1usmus 25 cycles stable)
View attachment 217998
APU's are so easy to tweak its not even funny, think i spent like 2 mins in the bios in total to achieve this

Impressive numbers on the 5950X!

Dunno if you watch i2hard on youtube? They ran both the 5600G and 5700G at 4533 1:1 and 16-flat. Performance with the 5600G 4533cl16 is close to 5600X 3800cl14, about 5-10% in games.

I bet you can get anywhere from 4400 to 4600 1:1

 

[Det0x]

CL13 run
Completed 25 cycles TestMem 1usmus cfg
1.55 vdimm with active cooling
Dual rank 2x16gb

Bigger Aida screen:

 

[freeagent]

Man that annoys me how 5900X is detuned. I don’t understand why 56,58,595 can hit low latencies but 59 is just a turd :/

 

[AVATARAT]

Man that annoys me how 5900X is detuned. I don’t understand why 56,58,595 can hit low latencies but 59 is just a turd :/

That's not true.
(from Internet)

 

[freeagent]

Ok well I guess my board is shit and I will get the one I really want.. my son can use my strix haha..

 

[tbob22]

Well, couldn't say no to a 7920x and MSI x299 PRO for $300, also snagged 64gb of dual rank 3200mhz Silicon Power memory for $220. Not too bad for just about the cost of a 5900x. Will be replacing my old E5-1680v2 / x79 workstation.

Just using the XMP profile. Subtimings are not great, write speeds seems a little low to me.

Currently at 4.4ghz and 3.2ghz on the mesh. Also included the zentimings from my 5600x build. I'm sure with a bit of tuning I can get over 100GB/s on read at least.

 

[justiceleague]

Hello everyone, i share my results here.
I9 10850k
Gigabyte Z490 Elite AC
G.Skill 2x16 Gb DRank kit
1. Pic: TB
2. Pic: Original XMP 3200 MHz
3. Pic: 4266 MHz, Dram 1,5V, IO & SA 1.31V
4. Pic: 4600 MHz, Dram 1.6V, IO 1.35V, SA 1.38V

Doing 54000MB/S in 10.5ns!
BE WARNED, MIGHT CAUSE DROOLING! I believe this is a new world record! It took me over 7 months and MANY MANY hours of long hard work, leaving no stones unturned to get these results. The current world record is 13.5ns but he was using a 2Gb stick and he has to push millions of volts to get it to posts. I guess as long as it posts to complete the benchmark then it's good enough for the judges. If you play any games on it, then there is no question it will blow up. Mine is rock solid! And passes every test out there. It passes 30 hours of memtest86, prime95 AVX/SSE 24HRS STR8! And last but not least, IMO is the hardest stress test to pass is OCCT AVX LARGE/ SSE MIX. Zero errors for 14 half hours. Playing on it is like to me feels like playing on a CPU that was overclocked to 7ghz using cryofreeze to kept it cool that I've tried out at a friend's house in the past. It is simply stunning and breathtaking and on another level of play once you go below 25ns with at least 3000 MHz. I have post 3 results over a 6months period and the Ram of choice that I used for this experiment. Thank Samsung for your B-DIE. I would have never achieved anything close to it without it.