Unigine Heaven 4.0 Benchmark Scores

[erocker]

Perhaps it should be clearer in the OP that the only tweak allowed is overclocking. Driver config, bench config (other than those outlined) need to stay at default values.

This thread is for posting your Heaven 4.0 scores. The guidelines are pretty clear on what you need to do. Try your best to stay on topic everyone.

Thanks.

 

[20mmrain]

Well did a new run with a CPU clock @ 4.5..... and GPU clocks of 1246 Core and 1861 Mem..... you guys are right the CPU has a little affect but not very much.
I think I will keep my top 3/Personal best score of 1780 for single GPU. But it doesn't look like I can push any higher considering my GPU started to artifact @ the fastest clocks I ran at which was 1277/1861.
A great experience, here I was able to find out my safest max GPU overclock is 1223 Core - 1861 Mem. I am farily impressed with the overclocking potential of the GTX 780ti. (Its no GTX 460 but its still great )
Still not bad for a Mini ITX system .....Hey?

Lower Score at 4.5 Ghz

 

[FX-GMC]

OP has been updated.

I appreciate those of you who came here with good intentions.

 

[fullinfusion]

Edit to post # 47 ppl

 

[Kaapstad]

4 x 290Xs @1240/1625
4930k @4.8 with BCLK 102
Score 5305

 

[fullinfusion]

4 x 290Xs @1240/1625
4930k @4.8 with BCLK 102
Score 5305

Nice score!

How do you find 4x crossfire on what driver?

 

[Kaapstad]

Nice score!

How do you find 4x crossfire on what driver?

Thanks

I am using 13.11 drivers

Quadfire works really well on some things like BF4 but on some things like Crysis 3 there is no support.

I don't want to use the Mantle drivers just yet until they have been around for a bit.

 

[fullinfusion]

Thanks

I am using 13.11 drivers

Quadfire works really well on some things like BF4 but on some things like Crysis 3 there is no support.

I don't want to use the Mantle drivers just yet until they have been around for a bit.

Im in the same boat...Dont trust them quite yet! But I've been using the 13.12's myself and had no issues.

I'll have to give those drivers a try to see whats up with them. I"m just a 290 cross-fire guy

 

[rodrigobenchmarker]

I Believe that i'm the only one with a dual core around here, LOL

however, it didn't affected my score, had the same graphics card with an i5 2310 in the past and scores were not much different

My rig:

Intel Pentium Dual Core G870 3,1Ghz (stock)
GTX 580 EVGA reference (blower) 815/1055
GA-Z68XP UD5
Antec HCG 620w

 

[Dagamus(NM)]

Hi Hi Hi, been reading these threads for awhile now and finally decided to join in.

Setup for benchmark:
4xSapphire 7950 10032-4L @ 1170/1570 in CCC
i7 3930k @ 4.6Ghz
Freezer blocks on my GPU radiator during runs

While I know I won't get to Kaap's scores on these cards, 3536 was the highest I could push these without the screen locking up during my runs. Unfortunately I did not get a screenshot with it running. Just the saved file, oh well. It doesn't make much of a difference anyway.

Perhaps the system might be a bit more stable at higher clocks if I reduced the amount of RAM used while running this bench or maybe lowered the speed of it. Increasing the CPU clock did seem to have an effect on my score, but not a more than a change of 25pts for every 200MHz above 3800.

I tried using Trixx to run the clocks on the cards higher as the Hynix RAM modules on these cards should be able to take more than what the max is in CCC, but when running Heaven it didn't recognize the settings of 1400/1800 and instead ran it and scored it as though I was at 925/whatever teh stock memory is. It seems that CCC on these cards are limited by what would be safe on Elpida memory but that I have a lot of room unused on the Hynix.

I'm sure I still have some tweaking left to do on my CPU primary and secondary voltages.

System specs are:
i7 3930k
ASUS Rampage IV Extreme mobo with EK MB Blocks on Bios 4804
Quad Fire 7950HD with EK waterblocks
Platimax 1350W PSU
64GB G.Skill RipjawZ 2133MHz memory kit
Corsair H100i for CPU
Phobya 400mm X-treme radiatior with 200mm BitFenix all black fans
Kingston 120Gb SSD
WD red 3tb HDD
Thermaltake level 10GT case (annoying LEDs removed)
Other bits and pieces

I think I am at about as far as I bother pushing this system. My pockets are not deep enough to get R9 290x's and then the waterblocks that go on them, plus I haven't even received the EK back plates that I ordered a couple weeks ago. I think I will mostly work on aesthetics of the system from here forward. The cable sleeving from the PSU are not the best looking and do not come up far enough to the connectors. The majority of the cabling is hidden so what is primarily seen is the wires that extend beyond the sleeve. I may switch out the 18ga wires with 16ga when I get around to redoing them. I only have flexible hose in my system but now that I am pretty settled on the routing of the water lines, I will move to acrylic soon. Just need the money to buy the extra fittings as I currently use 12 compression fittings. I do have a nice Steinel ESD safe digital heatgun programmable in 10 degree F increments so dealing with acrylic should be no problem. I digress, this thread is about GPU performance and I really don't have anywhere left to go unless I can figure out how to get past the 1200/1575 limits. These cards should be unlocked, but as of yet I cannot get past the 1200/1575 +20 power limits. I might not want to go past +20 power until increase my PSU PCIE power wire gauge anyway.

Glad to get on the board, should put me 4th on the multi GPU list. Will most likely need to get past CCC limits to make 2nd or even 3rd.

 

[sirbaili]

Hi Hi Hi, been reading these threads for awhile now and finally decided to join in.

Setup for benchmark:
4xSapphire 7950 10032-4L @ 1170/1570 in CCC
i7 3930k @ 4.6Ghz
Freezer blocks on my GPU radiator during runs

While I know I won't get to Kaap's scores on these cards, 3536 was the highest I could push these without the screen locking up during my runs. Unfortunately I did not get a screenshot with it running. Just the saved file, oh well. It doesn't make much of a difference anyway.

Perhaps the system might be a bit more stable at higher clocks if I reduced the amount of RAM used while running this bench or maybe lowered the speed of it. Increasing the CPU clock did seem to have an effect on my score, but not a more than a change of 25pts for every 200MHz above 3800.

I tried using Trixx to run the clocks on the cards higher as the Hynix RAM modules on these cards should be able to take more than what the max is in CCC, but when running Heaven it didn't recognize the settings of 1400/1800 and instead ran it and scored it as though I was at 925/whatever teh stock memory is. It seems that CCC on these cards are limited by what would be safe on Elpida memory but that I have a lot of room unused on the Hynix.

I'm sure I still have some tweaking left to do on my CPU primary and secondary voltages.

System specs are:
i7 3930k
ASUS Rampage IV Extreme mobo with EK MB Blocks on Bios 4804
Quad Fire 7950HD with EK waterblocks
Platimax 1350W PSU
64GB G.Skill RipjawZ 2133MHz memory kit
Corsair H100i for CPU
Phobya 400mm X-treme radiatior with 200mm BitFenix all black fans
Kingston 120Gb SSD
WD red 3tb HDD
Thermaltake level 10GT case (annoying LEDs removed)
Other bits and pieces

I think I am at about as far as I bother pushing this system. My pockets are not deep enough to get R9 290x's and then the waterblocks that go on them, plus I haven't even received the EK back plates that I ordered a couple weeks ago. I think I will mostly work on aesthetics of the system from here forward. The cable sleeving from the PSU are not the best looking and do not come up far enough to the connectors. The majority of the cabling is hidden so what is primarily seen is the wires that extend beyond the sleeve. I may switch out the 18ga wires with 16ga when I get around to redoing them. I only have flexible hose in my system but now that I am pretty settled on the routing of the water lines, I will move to acrylic soon. Just need the money to buy the extra fittings as I currently use 12 compression fittings. I do have a nice Steinel ESD safe digital heatgun programmable in 10 degree F increments so dealing with acrylic should be no problem. I digress, this thread is about GPU performance and I really don't have anywhere left to go unless I can figure out how to get past the 1200/1575 limits. These cards should be unlocked, but as of yet I cannot get past the 1200/1575 +20 power limits. I might not want to go past +20 power until increase my PSU PCIE power wire gauge anyway.

Glad to get on the board, should put me 4th on the multi GPU list. Will most likely need to get past CCC limits to make 2nd or even 3rd.

Me too watching this thread.

i7-3770k 4600mhz
1xAsus R9-290x watercooled - -1180mhz-1325mem.
Ek WatrerBlock On Gpu And Xspc Raystorm On CPU.
Score - 1483 -

 

[Kaapstad]

What will sometimes give a few extra points when using an i7 CPU is to disable Hyperthreading.

Also with a 3930k if you can use the 125 strap with a BCLK of around 129 this will overclock the PCI-E slots a little and can give a few more points. If you do this don't forget to adjust you memory speed and multiplier.

 

[Dagamus(NM)]

I'll give that a try, thanks.

 

[ninja85]

i can hear the Ti's breatin

i7 2700K@4,9Ghz | GTX 780 1320/1850

 

[Fizban]

Might as well throw a laptop score in there:

No incrementing needed since I came dead las

GPU Clocks are 809 mhz core 1002 mhz memory.

 

[FX-GMC]

Might as well through a laptop score in there:

No incrementing needed since I came dead las

GPU Clocks are 809 mhz core 1002 mhz memory.

If we get a few more laptop/mobile card runs I'll start a new table for them.

 

[Fizban]

I will play with the gpu clocks, I'm actually a bit disappointed that my laptop didn't score higher than the 7850 did, I'll try and at least crack 500.

EDIT: I don't think that's going to happen. the first score shown was already overclocked, stock speeds it scores 444.

 

[the54thvoid]

i73930k @ 4.4Ghz
GTX 780ti Classified 1372Mhz core @ 1.325v 1825(7300)Mhz memory. Temps at 46 degrees.

Which is only 10% faster than my old Titan's best score.

 

[Fizban]

This looks to be as good as it is getting:

469 with the core at 825 mhz (memory still at 1002, if I so much as budge the memories clockrate it becomes unstable).

Also up to you what to put in the table, but the 2.4 GHz it shows for cpu is a bit misleading, that's base clock, the laptops still use turbo boost so it actually goes up to 3.4 GHz on all 4 cores so long as temps allow (3.2 GHz stock, but I use Intel Extreme Tuning Utility to raise the max multiplier by 2 allowing it to go 3.4 GHz on all 4 cores, or 3.6 GHz on 1 core instead of the 3.4 and 3.2 that are the stock maximums.

 

[erocker]

Figured I'd run at my 24/7 settings:



13.12 WHQL drivers.

|i7-3770K | 4.6GHz | HD 7970 | 1250/1650 | 1069 | erocker

 

[FX-GMC]

This looks to be as good as it is getting:

469 with the core at 825 mhz (memory still at 1002, if I so much as budge the memories clockrate it becomes unstable).

Also up to you what to put in the table, but the 2.4 GHz it shows for cpu is a bit misleading, that's base clock, the laptops still use turbo boost so it actually goes up to 3.4 GHz on all 4 cores so long as temps allow (3.2 GHz stock, but I use Intel Extreme Tuning Utility to raise the max multiplier by 2 allowing it to go 3.4 GHz on all 4 cores, or 3.6 GHz on 1 core instead of the 3.4 and 3.2 that are the stock maximums.

I used base clock for the stock desktop processors also.

Figured I'd run at my 24/7 settings:

13.12 WHQL drivers.

|i7-3770K | 4.6GHz | HD 7970 | 1250/1650 | 1069 | erocker

Thanks for making it easy on me.

 

[rodrigobenchmarker]

New NVIDIA Beta drivers 337.50

No vram overclocking, just increased gpu clock

GTX580
885/1002

Position number 42, here i am. xD

 

[rodrigobenchmarker]

I think we have a new fastest GTX 580 in this thread

GTX 580
948/1024

 

[FX-GMC]

I think we have a new fastest GTX 580 in this thread

GTX 580
948/1024





View attachment 56008

Nice.

 

[GreiverBlade]

I think we have a new fastest GTX 580 in this thread

GTX 580
948/1024





View attachment 56008

oh wait i didn't noticed that was my 580 who had that "title" bahahah