Installation

To install the MasterLiquid Maker 92, start by preparing the backplate for mounting to the motherboard. Once in place, apply some thermal paste to the CPU.


Mount the cooler to the CPU to then use the included thumbscrews to secure it in place.


All that's left is to plug in the power connectors if you unplugged any. I had to plug the fans into the pump unit and had to hook the pump up over SATA and a CPU header. Everyone else just needs to plug in the CPU header and SATA power connectors.

The installation procedure is similar outside of a case. However, inside a case, tightening down the thumbscrews may prove a bit more difficult. As such, I would rate the process an 8 on a scale of 1 (hardest) to 10 (easiest).