Unpacking & assembly

The case arrived in a brown box, inside, everything was very well packed. And I really do mean very, very well packed – the panels rest on dampening foam, additionally, each panel is packed separately in plastic wrap. Furthermore, each panel is covered from one side with paper. This prevents it from getting scratched, and makes handling easier. Two pairs of white gloves are provided, so you don’t get your fingerprints on the case. As you can see, everything needed for assembly is split up into zip-loc bags that are clearly labeled. This makes installation a lot easier. Danger Den also gives you a very nice vandal-proof switch to power on your PC.


Assembly of the case was relatively easy and took about 1 hour. There was a slight issue with one of the screws on the I/O Shield, as it didn’t fit (the hole on the metal shield would not align with the one in the motherboard tray.) Now, one screw probably wouldn’t make a difference, but just to be sure I took a file and enlarged the screw hole on the metal shield – then, everything was OK. Also, there is a mistake in the instructions, which suggested the use of screws in bag 15 instead of those clearly labeled “I/O shield” Following my intuition, I used the I/O shield screws without any problems. Before you even begin assembling the case, do yourself a favor though – head out to a DIY store and purchase a proper screwdriver. All of the screws provided with the case have the same head, so one screwdriver will do. Being in Europe, I ended up using a 2.5mm hex screwdriver, which fit the screw heads fine. The only time I needed to use the allen wrench was when screwing in the bottom three screws on the I/O shield. I also recommend not to throw away the packaging, as it comes in handy when you assemble the case. I used the box as support during assembly as you can see in one of the pictures above.


As the picture above shows, most of the time, you do not screw into the acrylic directly. Instead, Danger Den has designed a clever system, where you place the screw into the acrylic and secure it on the opposite end with a nut. This should yield less stress on the panels.

Once you assemble the whole case, it is necessary to loosen all of the screws, and get all the panels aligned (getting someone to help you makes this process much, much easier).

Then, you’re ready to install all of the hardware!