Netgear ProSAFE Click 16-Port Ethernet Switch Review 7

Netgear ProSAFE Click 16-Port Ethernet Switch Review

EMC Pre-Compliance Testing »

ProSafe Plus Utility


In case you aren't aware of the default IP (192.168.0.239) for the web interface, it is on the label on the bottom of the switch. You will have to install and run Netgear's ProSafe Plus utility, which will discover the switch inside your network. The same application will also allow you to change the default IP address.

Web Interface


The default password is "password".

Main MenuSubmenu #1Submenu #2
SystemManagementSwitch Information
Port Status
Loop Detection
Port LED Control
MaintenanceChange Password
Device Reboot
Factory Default
Firmware Upgrade
Save Configuration
Restore Configuration
MonitoringPort Statistics
Mirroring
Cable Tester
MultiCastIGMP Snooping
LAGLAG Configuration
LAG Membership
VLANPort BasedBasic
Advanced
802.1QBasic
Advanced
QoSQoSQoS Mode
Rate LimitRate Setting
Broadcast FilteringEnable/Disable
HelpOnline HelpUser Quide
RegistrationProduct Registration
You can take a glimpse at all the options, menus, and sub-menus the web interface features in the table above.
Next Page »EMC Pre-Compliance Testing
View as single page
Dec 2nd, 2024 09:39 EST change timezone

New Forum Posts

Popular Reviews

Controversial News Posts