Packaging

The Card

The NVIDIA GeForce RTX 3060 Ti Founders Edition looks nearly identical to the RTX 3070 Founders Edition, except that the metal frame is in a bright silver color now. I like this look even better than the other GeForce 30 FE cards—so beautiful.


Dimensions of the card are 24 x 11.5 cm, and it weighs 1051 g.


Installation requires two slots in your system.


Display connectivity options include three standard DisplayPort 1.4a and one HDMI 2.1. Interestingly, the USB-C port for VR headsets, which NVIDIA introduced on the Turing Founders Editions, has been removed—guess it didn't take off as planned. The DisplayPort 1.4a outputs support Display Stream Compression (DSC) 1.2a, which lets you connect 4K displays at 120 Hz and 8K displays at 60 Hz. Ampere can drive two 8K displays at 60 Hz with just one cable per display.

Ampere is the first GPU to support HDMI 2.1, which increases bandwidth to 48 Gbps to support higher resolutions, like 4K144 and 8K30, with a single cable. With DSC, this goes up to 4K240 and 8K120. NVIDIA's new NVENC/NVDEC video engine is optimized to handle video tasks with minimal CPU load. The highlight here is added support for AV1 decode. Just like on Turing, you may also decode MPEG-2, VC1, VP8, VP9, H.264, and H.265 natively, at up to 8K@12-bit.

The encoder is identical to Turing. It supports H.264, H.265, and lossless at up to 8K@10-bit.


Just like the RTX 3070, 3080 and 3090 Founders Edition, the RTX 3060 Ti FE uses the new NVIDIA 12-pin power input. This connector has been talked about a lot, it's basically a much more compact solution to provide a lot of power for the card. The 12-pin carries up to 300 W of power, the equivalent of two 8-pin PCIe power cables. On the RTX 3060 Ti and 3070, NVIDIA doesn't need that much power, so the adapter cable uses only a single 8-pin. Total available power is 225 W (150 W from the 12-pin + 75 W from the PCIe slot). With every Founders Edition, NVIDIA includes an 8-pin to 12-pin adapter cable, so you're good to go and don't need any special adapters.

I'm not happy with the placement of the 12-pin, though. It's right in the middle of the card and goes straight upwards, which makes cable management a pain. I really wonder why NVIDIA didn't position it better, the card is short enough to even place it on the back.


The GeForce RTX 3060 Ti does not support SLI. Only the RTX 3090 has very limited SLI support.

Teardown

NVIDIA's thermal solution combines a large copper base with four heatpipes. Also note the thermal pads, which provide cooling for the memory chips and VRM circuitry.


The backplate is made out of metal and protects the card against damage during installation and handling. It comes with a small thermal pad that soaks up a little bit of heat from the memory VRM on the other side of the PCB.