Packaging and Accessories

You might be wondering what those three modes reflected in the specifications table are all about, which we will certainly cover in the review. First up is the packaging and the unboxing experience itself, and this is also how I can show you that the T30-120 will come in two SKUs—as a single or triple pack. Phanteks sent me one of each, which also makes testing multiple samples for any sample variation possible and adds statistical accuracy to our objective testing. Both sets employ a thick Styrofoam box with a cardboard cover, which has a render of the fan on at its face as a teaser, along with the company logo, product name, and the same "The Ultimate Fan" tagline we saw before. The back covers the technical specifications again and delves into more detail about the three available operating modes for the fan. A look at the side confirms the triple pack is just composed of three individual packs, with the Phanteks logo on the foam for further branding. A seal and double flap common across both SKUs keep the contents in place during transit.


I am using the single pack to demonstrate the rest of the unboxing experience. Opening the box, we see a few lines in blue for contrast with the grayscale thus far, which also matches the fans themselves in a nice touch. There are instructions on how to access the three modes, and I can now also tell you that there is an onboard switch on each fan which not only changes the maximum RPM, but also introduces an on/off mode. The associated RPM response curves are seen here, as well as a list of included accessories for further transparency. This was another layer of the same cardboard cover we saw thus far, and lifting it off finally reveals the fan inside a foam compartment with the accessories to the side in a second, smaller compartment. A cutout connects the two to allow the fan wire to go through, and the accessories otherwise come packaged separately as seen above.


There is the expected set of four self-tapping screws for use as a case fan, but we then see some long screws too, which is strange until you remember that the Phanteks T30 is a 30-mm thick fan. As such, the standard screws supplied with radiators may not be long enough. Alphacool is among the few to include 35-mm-long M3 screws with its radiators, which is a good thing too since these are 36-mm long UNC 6-32 screws that work well with most CLCs but won't be compatible with many DIY cooling radiators available today. So you will have to buy longer M3 or M4 screws depending on your radiator of choice should you wish to go with Phanteks T30 fans. There is a slightly longer version of the same screws, and this 39 mm long set is for the optional Phanteks Halos RGB fan frame since these are otherwise sparse on RGB lighting. A 50 cm long extension cable with thin, cheap-ish feeling sleeving and standard male-to-female 4-pin PWM connectors on both ends is also included with each fan.


For those wondering, the triple pack opens up to reveal three individual packs stacked one above the other. There is no bundled controller or any other extra accessory. The reason to go with the triple pack of the Phanteks T30 is a small cost saving over three individual packs, as well as a more compact box heading your way should you need three (or more) of these fans.