Cross Load Tests
For the generation of the following charts we set our loaders in auto mode, through our custom software, and try over a thousand possible load combinations with +12V, 5V and 3.3V rails. The voltage regulation deviations in each of the below charts are calculated taking the nominal values of the rails (12V, 5V and 3.3V) as point zero. We should note here that we will run this test only with PSUs that have capacity equal or lower than 800W since it takes way too long and as the capacity increases the completion time increases exponentially.
+12V Voltage Regulation Chart
5V Voltage Regulation Chart
3.3V Voltage Regulation Chart
Efficiency Chart
+12V Ripple Chart
5V Ripple Chart
3.3V Ripple Chart
5VSB Ripple Chart