Cross Load Tests
For the generation of the following charts, we set our loaders to auto mode through our custom-made software before trying over a thousand possible load combinations with the +12V, 5V, and 3.3V rails. The load regulation deviations in each of the charts below were calculated by taking the nominal values of the rails (12V, 5V, and 3.3V) as point zero. We should note here that we usually only run this test with PSUs that have a capacity equal to or lower than 1.3 kW since it takes a long time to run and because its completion time increases exponentially as the capacity of a unit increases. But in this case we decided to make an exception.
+12V Load Regulation Chart
5V Load Regulation Chart
3.3V Load Regulation Chart
Efficiency Chart
+12V Ripple Chart
5V Ripple Chart
3.3V Ripple Chart
5VSB Ripple Chart