A Closer Look - Inside

Corsair has tried to implement the same internal structure within the Graphite 600T as with the Obsidian series, as cable management has been made as easy as possible. A large opening in the mainboard tray should give you unrestricted access to the underside of the socket area, while plenty of cable routing possibilities should make it very easy to keep everything clean inside.


You may install up to six hard drives within the Graphite 600T. Each is to be placed in a tray and then pushed in until it snaps into place. The pins that hold the hard drives, are rubber mounted to eliminate any vibrations. Corsair also allows you to take the two cages - holding three drives each - out completely or gives you the possibility to place it on the floor of the chassis. This creates enough free space for even the longest graphic cards out there, without sacrificing any expandability. A 200 mm, LED equipped fan cools these drives.


Moving one up, the four 5.25 inch bays are equipped with plastic locks. I was sitting there at first, wondering how these would work, but upon closer inspection it became apparent, that the locks act as a lever, which works surprisingly well as we will see later on.


In the rear, starting at the bottom, we have the PSU bay. There is no foam lining or rubber mounts anywhere, but Corsair has included a support bar, similar to that found in some Thermaltake cases, but this one is actually functional, as it does not force you to remove screws from the underside of the case. Instead, you just take off the thumb screws, move the bar into place and pin it down with the screws. Above that are the eight mainboard expansion slots along with two openings for water cooling. Corsair has implemented the same basic USB connectivity as most other manufacturers, but has included a basic expansion slot cover with a hole to route the cable through. Moving on up, we have a 120 mm cooling fan which comes pre-installed within the 600T.


The third and last fan, also 200 mm and LED equipped, can be found on the ceiling of the chassis. It pushes air out the top of the case and may be replaced by 2x 120 mm units or a dual 120 mm radiator.


Before we dive into the assembly process, let us take a quick look at the cables within the chassis. All of them are black to go well with the rest of the chassis. There are four fan headers to connect to the big dial on top of the chassis. This controller is powered by a simple Molex connector. Besides that there are all the standard headers present to connect everything to the mainboard, along with the USB 3.0 connector.