Overclocking

To find the maximum overclock of our card we used a combination of GPUTool and our benchmarking suite.
The overclocks listed in this section were achieved with the default fan and voltage settings as defined in the VGA BIOS. Please note that every single sample overclocks differently, that's why our results here can only serve as a guideline for what you can expect from your card.



The overclocks of our card are 895 MHz core (10% overclock) and 1170 MHz Memory (14% overclock). An additional overclock of 10% over the already increased out of the box clocks is very respectable and seems to be higher than that of other reference design cards. According to ZOTAC some special card binning is happening at the factory which could explain this improvement.

Overclocked Performance

Using these clock frequencies we ran a quick test of Call of Duty 4 to evaluate the gains from overclocking.


The actual 3D performance gained from overclocking is 8.0%.

Temperatures

Temperatures seem to be well optimized. A little higher idle temperature for less idle fan noise would be something I'd prefer, but overall the temperature looks good. (Tested with Crysis, not Furmark).

Voltage Tuning

It has been a long known fact that overclocking headroom increases as soon as you increase the operating voltage. Until recently, software voltage control on VGA cards has been the exception and most users were not willing to risk their warranty by performing a soldering voltmod. Nowadays almost all current graphics cards have voltage control in order to achieve low power consumption by lowering voltage when in idle or slightly loaded.
In this section we will increase the GPU operating voltage step by step and record the maximum clock speed possible. Voltage is listed as the value that the voltage regulator reports via software, not actual measured voltage. The card was installed in-case, with fan settings at the default, memory will not be overclocked either. If a card has thermal throttling we will reduce the operating frequency to keep performance at maximum for a given voltage. Please note that the fan profile will have an effect on observed temperatures: if the card gets hotter the fan will ramp up to reduce temperatures or keep them from rising fast.

The following graph shows the overclocking potential we saw on our sample. GPU clock is represented by the blue line, which uses the vertical clock scale on the left. The scale starts at the default clock to give a feel for the overclocking potential over the base clock. Temperature is plotted in red using the °C scale on the right side of the graph. An additional graph shows the full system power draw in orange measured at the wall socket when running at the given voltage, clock & temperature.



The card gains nicely with voltage increases - just like the reference design. Unfortunately it hits a heat wall around the 900 MHz mark which could have been solved if ZOTAC used a different thermal solution.

Clock Profiles

Modern graphics cards have several clock profiles that are selected to balance power draw and performance requirements.
The following table lists the clock settings for major performance scenarios and the GPU voltage that we measured. We measure on the pins of a coil or capacitor near the GPU voltage regulator.