Wednesday, December 5th 2018
Raijintek Intros MYA RBW CPU Cooler
Raijintek today introduced the MYA RBW, a large aluminium fin tower-type CPU cooler with addressable RGB embellishments. The cooler was first shown off at Computex 2018. Its design involves a heavy aluminium fin-stack with ridged fins that have increased surface area over flat fins, capped off by a composite top, with a silicone RGB LED diffuser, and a brushed metal top-plate. Heat drawn by six 6 mm-thick nickel-plated copper heat pipes pass through the fin-stack.
At the base, these heat pipes make direct contact with the CPU. A 13 mm-thick slimline hydraulic bearing 120 mm fan compensates for the fin-stack's thickness, as does the vertical offset in the fin-stack itself, freeing up room near your motherboard's memory slot area. The fan spins between 200 to 1,400 RPM, pushing up to 41.71 CFM of air and a 28.43 dBA minimum noise level. Measuring 130 mm x 86 mm x 163 mm (WxDxH), the cooler weighs about 925 g, including the fan. Among the CPU sockets supported are Intel LGA2066, LGA115x, and AM4. The company didn't reveal pricing.
At the base, these heat pipes make direct contact with the CPU. A 13 mm-thick slimline hydraulic bearing 120 mm fan compensates for the fin-stack's thickness, as does the vertical offset in the fin-stack itself, freeing up room near your motherboard's memory slot area. The fan spins between 200 to 1,400 RPM, pushing up to 41.71 CFM of air and a 28.43 dBA minimum noise level. Measuring 130 mm x 86 mm x 163 mm (WxDxH), the cooler weighs about 925 g, including the fan. Among the CPU sockets supported are Intel LGA2066, LGA115x, and AM4. The company didn't reveal pricing.
9 Comments on Raijintek Intros MYA RBW CPU Cooler
It would also depend on what cpu you are trying to cool, at what voltage and at what speed too....
You could always try it, and replace the stock fan with something beefier if not satisfied :)
Couple of cpu benchmarks and boom, results ;)
Have Cryorig C1 that came with slim 140mm fan. I used exact same fan, standard thickness 25mm. The temps were maybe 1c difference on average.