Tuesday, April 2nd 2019
Alphacool Unveils the Eisbaer Refill Kit
Alphacool today unveiled the Eisbaer Refill Kit. The refill kit contains all of the important tools you need to fill your Eisbaer CPU water cooling system with a few simple steps. This includes a funnel with G1/4" thread, a high-quality thermal paste in a syringe, an adapter cable for the pump and an ATX jumper plug.
Remove the Eisbaer from your ensuring your power supply is turned off. Unplug the 24-pin ATX connector from the mainboard and fit the ATX jumper plug to it. Place the radiator on a table and the Eisbaer CPU/pump/Reservoir unit on a slightly elevated surface. Then simply mount the funnel on the fillport. With the SATA to 3-pin adapter cable you can now connect the pump of the Eisbaer to your power supply. Now slowly fill the Eisbaer with your liquid until the reservoir is full. Now you can switch on the power supply again. The ATX bridging plug starts the power supply unit and the pump of the Eisbaer starts to work. It is important that you turn off the pump occasionally to refill with liquid. The pump must never run dry.
When the Eisbaer is full, you can plug the fillport again. Then let the Eisbaer run a little outside your case, while you shake the Eisbaer in all directions. Ideally, always hold the radiator lower than the Eisbaer CPU/pump/Reservoir unit unit so that the air can move upwards into the reservoir. You will notice that you may need to top up some liquid. The reservoir should be approximately 90% full at the end of the procedure.
MSRP: 9.95€.
Remove the Eisbaer from your ensuring your power supply is turned off. Unplug the 24-pin ATX connector from the mainboard and fit the ATX jumper plug to it. Place the radiator on a table and the Eisbaer CPU/pump/Reservoir unit on a slightly elevated surface. Then simply mount the funnel on the fillport. With the SATA to 3-pin adapter cable you can now connect the pump of the Eisbaer to your power supply. Now slowly fill the Eisbaer with your liquid until the reservoir is full. Now you can switch on the power supply again. The ATX bridging plug starts the power supply unit and the pump of the Eisbaer starts to work. It is important that you turn off the pump occasionally to refill with liquid. The pump must never run dry.
MSRP: 9.95€.
6 Comments on Alphacool Unveils the Eisbaer Refill Kit
i do not like reservoir placed lower than rad.. you will have half of the rad filled with air and bubble going in circle (and so lower thermal conductivity in both WB and RAD)
"long time ago" there were 5.25" reservoir or tube-style placed in the upper end of the case and so the filling of loop was easy and well done.. now you have reservoir placed bottom.
i do not understand why business focalize more on eastethics than performance.
bubble...bubble everywhere
The small bubble of air inside the res is irrelevant, as long as window faces up.
Dont blame a product if you dont know what/how to do stuff, and dont want to spend 5min on google..
no need to buy everything (in plastic) when you got good alternatives at home or you got enough plastic bottles at home.